MTM Hydro PF22 Foam Cannon with Soap

MTM Hydro PF22 Foam Cannon with Soap

Whether you are foaming down your car on the weekend or you are a professional contract cleaner foaming hog barn for hours, this tool will save you time and money. Simply attach the foam cannon to your pressure washer using one of the included fittings, fill with your desired ratio of chemical and you are up and running.

Details:

• • Comes standard with a wide mouth bottle
• • Offers both adjustable fan blades and a two stage nozzle allowing you to spray vertically and horizontally
• • By adjusting the fan blades (narrow or jet), can throw thick foam onto your vehicle, pole barn siding, house, fence, sidewalk, roof or other washable items
• • The chemical injection knob on top of the PF22 clicks and allows for precise measurement of more or less chemical to be drawn through the internal chamber, increasing or decreasing the foam output.
• • The thick foam has a longer dwell time which allows the chemical to work on the cleaning surface for longer in its effort to emulsify the dirt and grime
• • Some surfaces may still require some elbow grease, however, if the chemical does its job then very little (if any) scrubbing is required
• • Min. 1,100 PSI - Max. 5,000 PSI
• • Min. 1.4 GPM - Max. 5.3 GPM
• • Max. 140°F

NOTE: The full spectrum of ratings are not supported by the 3.5 or 3.0 orifices included with this kit. Other orifices may be required for higher flow machines that have lower PSI. For example: 2000 PSI with 3.5 GPM requires a 5.0 Orifice. For larger orifices, you will know it does not work because you will experience starting and stopping of the foam cannon as your unloader slips in and out of bypass. You will also get watery foam as the orifice size 3.5 is significantly smaller than the 5.0 needed for your machine. MTM Foam Cannons will not work with flow sensing unloaders as you will experience the same results listed for an under-sized orifice. 

Includes:

• • Italian Nickel Plated Brass -Single Cast Foam Cannon body
• • Italian Calibrated 32 oz wide mouth bottle and bottle adaptor
• • 1/4" x 9" tube for drawing chemical
• • 3.5 Orifice (1.25mm) installed in the Foamer Body
• • 3.0 Orifice (1.1mm) included with kit
• • Fitting pack (2-pieces) containing a 1/4" M22 adaptor and 1/4" QC Plated Steel Plug *
• • Manual with care instructions and exploded view
• • Hi-Foam PerFOAMance car shampoo

NOTE: A specific 1/4" Male plug may be required in order to attach the QC plug to the end of some residential pressure washer setups. MTM Hydro 1/4" plugs are standard for industrial use but many residential pressure washers such as Generac, Greenworks, Ryobi, AR Blue Clean, etc. have certain models where the coupler will not receive an MTM plug. Not all of these brands are impacted, just certain models. If you look closely, the Chamfer at the end of an MTM plug as well as the neck is, 1.5mm shorter than some couplers may allow.